pwnagotchi bluetooth tether GPS termux-location

[krishenriksen]

Share GPS location from android to pwnagotchi

[jayofelony]

Have you tested this?

[krishenriksen]

Yes, I made it, proper nmea sentences with checksum calculation.

[jayofelony]

Thats awesome, is there a way of implementing this into the bt-tether plugin as an extra?

[krishenriksen]

Very possible, however I cannot make the bluetooth connection stable enough on raspberry pi zero 2 w where as it works just fine on raspberry pi zero w, and I guess most people make pwnagotchi on 2 W now, so it doesn't make sense to allocate more time to this.

On my Raspberry Pi Zero 2 W I have to resort to the following almost every 20 minutes:

sudo lsof | grep bluetooth
sudo systemctl stop NetworkManager
sudo systemctl stop bluetooth
sudo modprobe -r hci_uart
sudo modprobe hci_uart
sudo systemctl start bluetooth
sudo systemctl start NetworkManager
bluetoothctl power on
bluetoothctl connect MAC_ADDRESS
sudo nmcli connection show
sudo nmcli connection modify "A24 Network" ipv4.method manual ipv4.addresses "192.168.44.30/24" ipv4.gateway "192.168.1.1" ipv4.dns "192.168.1.30"
sudo nmcli connection modify "A24 Network" ipv6.method ignore
sudo nmcli connection up "A24 Network"

[krishenriksen]

Thats awesome, is there a way of implementing this into the bt-tether plugin as an extra?

I did it anyway...

#233

[krishenriksen]

Made a small mistake, corrected the invalid coordinates in regards to NMEA 0183 standard.

Also changed the tty device to /dev/ttyUSB0 because bettercap keeps defaulting to this.

[krishenriksen]

Updated with VTG

Bearing and Speed:

The VTG sentence includes:
    Bearing (true north) in degrees.
    Speed in knots and kilometers per hour.